10
The tightening torque depends on the duration
of the impacting/tightening action. The largest
tightening torque is achieved after approx.3 to 5
sec. impacting/tightening action.
The torque build-up depends on the following
factors:
·
Hardness of the bolts/nuts.
·
Type of washer (disk washer, spring washer,
seal).
·
Hardness of the material to be joined.
·
Lubricating effect at the surface of the junction.
WARNING:
Hold the tool firmly.The torque
force may hurt you.
APPLICATION
1.
Be sure the rotational direction is “Forward”.
2.
Start the fastener by hand onto or into its
threaded counter part (e.g. nut onto bolt, bolt
into nut or threaded hole).
3.
With the proper impact socket securely
mounted to the wrench, slide the impact socket
onto the nut or bolt head.
4.
Hold the tool securely with both hands and
squeeze the trigger switch. The impact socket
will turn the fastener and impacting will begin
once the fastener encounters resistance.
WARNING:
Do not over tighten, as the force
of the Impact Wrench can break the fastener.
Keep the Impact Wrench at a right angle to the
fastener to avoid damaging the fastener head.
TOOL MAINTENANCE
WARNING:
Before any work on the machine
itself, remove the battery pack from the drill.
1.
Inspect bolts periodically. If the bolts loosen,
tighten them immediately, or will result in
serious accident.
2.
Inspect tool cords periodically. If damaged,
have repaired at your nearest Authorized
Service Center.
3.
Keep the vents clean. Clean all parts of the
tool, clean dust periodically. To prevent debris
from entry.
4.
Replace the carbon brush when the carbon
brush is worn out in certain length and motor
stops running. All maintenance should be
carried Out by Authorized
Service
Center, and only use identical
repair
parts.
5.
All service MUST only be performed by
Authorized Service Center. ALWAYS use only
accessories that are recommended for this
tool.
6.
Cleaning. Avoid the use of plastic cracks
caused by damage to the solvent. Use clean
cloths and mild soap to remove dirt, dust, etc.
WARNING:
Do not allow the water entering
the motor and the tool full immersed in the
