9
6. TO ATTACH BATTERY PACK
WARNING:
Use only
lithium-ion
batteries with the voltage listed on the nameplate
of your power tool. Using other batteries can lead
to injuries and pose a fire hazard
。
NOTE:
Use of batteries not suitable for the
machine can lead to malfunctions of or cause
damage to the power tool.
1. Lock the trigger switch on the Cordless drill by
placing the direction of rotation (forward/reverse/
center lock) selector in the center position.
2. Align the raised rib on the battery pack with
the grooves on the bottom of the Drill, and then
attach the battery pack to the Drill.
NOTE:
Make sure that the latch on the battery
pack snaps into place and the battery pack is
secured to the tool before beginning operation.
7. DIRECTION-OF-DIRECTION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
The direction of bit rotation is reversible and is
controlled by a selector located above the trigger
switch. The Cordless drill will not run unless the
direction of rotation selector is engaged fully to
the left or right.
With the Drill held in normal operating position:
1. Position the direction-of-rotation selector to the
left of the tool for forward rotation.
2. Position the direction-of-rotation selector to the
right of the tool for reverse rotation.
3. Setting the switch in the OFF (center lock)
position helps reduce the possibility of
accidental starting when not in use.
CAUTION:
To prevent gear damage, always
allow the Cordless drill to come to a complete
stop before changing the direction of rotation.
8. VARIABLE SPEED
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
9. TRIGGER SWITCH
To begin rotation, depress the trigger switch. To
stop rotation, release the trigger switch.
10. LED WORKLIGHT
The LED worklight, located on the base of
the Cordless drill, will illuminate when the
trigger switch is depressed. This provides
additional light on the surface of the workpiece
for operation in lower-light areas. The LED
worklight will turn off when the trigger switch is
released
11. ELECTRIC BRAKE
To stop the drill, release the trigger switch and
allow the chuck to come to a complete stop.
The electric brake quickly stops the chuck from
LED
worklight
Variable
speed
trigger
switch
Summary of Contents for DD1813
