Trim elevator pylon height and glue elevator to pylon with thin CA.
Then check elevator alignment to the wing and glue pylon to the
fuselage with thin CA.
Put rudder to the fuselage, check if the perpendicular to the elevator
and in the axis of the fuselage and glue it with medium CA.
elevator
right aileron
left aileron
medium
CA
Before you glue the servo board into fuselage, carefully check the
function of the RC system and set up neutrals of all servos. Then glue
it with thick CA.
Complete aileron pushrods, connect wires to the servo arms
with Z-bends and to ailerons horns with simply bends, check free
movements and neutrals of ailerons and glue pushrods to the
fuselage using medium CA.
Connect the elevator horn to servo arm with attached wire leader.
Install receiver and battery in the fuselage and check the center of
gravity. Program the transmitter and fly!
Recommend initial settings
Centre of gravity ....................................................42 mm from leading edge
Ailerons deflection ............................................................ up and down 5 mm
Elevator deflection ............................................... 3 mm up and 5 mm down
Brake ............................... ailerons 15 mm down and elevator 2 mm down
m2model wishes you a lot of fun with your Discovery micro!
receiver
battery
servo
servo
servo
medium
CA
Cut elevator control surface
by burnt labels, sand bevel
on both parts and fix the
elevator control surface to
stabilizer with self adhesive
tape (Scotch Crystal e.g.).
Install torsion spring and glue
elevator arm with thin CA.
cut off
