R3-PA16
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-8389 Rev.7 P. 2 / 6
COMPONENT IDENTIFICATION
RUN LED
1
11
12
13
14
15
16
17
18
19
20
2
3
4
5
6
7
8
9
10
ERR LED
Status Indicator LED
9
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
■
FRONT VIEW
■
SIDE VIEW
SW3
ON
4
3
2
1
Count Reset
Count Reset Input
Set the Count Reset SW to OFF to start counting.
Functions
Count Setting
from Host PC/PLC
■
STATUS INDICATOR LED
RUN indicator:
Bi-color (red/green) LED;
Red when the bus A operates normally;
Green when the bus B operates normally;
Amber when both buses operate normally.
ERR indicator
: Bi-color (red/green) LED;
Red with excitation abnormality;
Green in normal operating conditions.
Input status indicator
: Red LED; turns on with the input
ON.
■
SIDE DIP SW
(*)Factory setting
• Count Reset: SW3-1
SW
COUNT RESET
NORMAL
COUNT RESET
SW3-1
OFF (*)
ON
Note: Be sure to turn OFF during use.
• Count Reset Input: SW3-3
SW
COUNT RESET INPUT
INVALID
VALID
SW3-3
OFF (*)
ON
• Count Setting from Host PC/PLC: SW3-4
SW
COUNT SETTING FROM HOST PC/PLC
COUNT RESET
COUNT PRESET
SW3-4
OFF (*)
ON
(For option /PRS, count preset is ON)
Note : Be sure to set unused SW3-2 to OFF.
PC CONFIGURATOR
With configurator software, settings shown below are available.
Refer to the software manual of R3CON for detailed operation.
• Max. Pulse count: 1 to 65,535 (factory setting: 10,000)
• Totalized count value (V2.01 or higher)
• Accumulated pulse count (Pulse counts are changeable by using the PC Configurator, refer to “Counter setting from host
PC/ PLC” section hereafter.)
