21
DL8 USERS
MANUAL EM-7691-B Rev.24
5.2 CONFIGURATION
After mounting all I/O modules, configure each module.
(1) Install the R8CFG program to a PC. Connect the COP-US cable between the R8CFG port (I/O) of DL8 and the PC.
Install the driver software of COP-US to the PC in advance and take a note of the COM port number which has been
added. Turn on the power supply of the DL8 before connecting it to the PC.
COP-US
R8CFG
I/O
(2) Configure sensor type, signal range and other parameters of the I/O modules according to their manuals.
NOTE
• I/O module configuration cannot be performed via network.