CTS2
P. 2 / 3
EM-902
■
CONNECTION DIAGRAM
■
CURRENT PROBE DIMENSIONS mm (inch)
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the connection diagram at the front of the unit.
■
TRANSMITTER DIMENSIONS mm (inch)
INSTALLATION
Detach the yellow clamps located at the top and bottom of the unit for separating the body from the base socket.
■
TRANSMITTER
Current Probe
Mounting
Attachment
Conductor
Recommended mounting method
Binding
Strap
Connector
• DIN Rail Mounting
Set the base socket so that its
DIN rail adaptor is at the bot-
tom. Position the upper hook
at the rear side of base socket
on the DIN rail and push in
the lower. When removing
the socket, push down the
DIN rail adaptor utilizing a
screwdriver (–) and pull.
• Wall Mounting
Refer to the drawings next.
Clamp
(top & bottom)
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
Shape and size of the base socket
are slightly different with various
socket types.
190 (7.48)
max.
9.9 dia.
(.39)
L 610
8 meters
(26.4 ft)
CONNECTOR
5 dia.
(.20)
R 60 (2.36) min.
(minimum curvature radius)
+
–
OUTPUT
1
U(+)
V(–)
POWER
7
8
2
3
4
5
6
SOURCE
LOAD
CT
3
4
5
6
2
1
8
7
80 (3.15)
50 (1.97)
103 (4.06)
136 (5.35)
[3.3 (.13)]
80 (3.15)
20 (.79)
35.4 (1.39)
40 (1.57)
50 (1.97)
7.8 (.31)
CLAMP
(top & bottom)
DIN RAIL
35mm wide
2-4.5 (.18) dia.
MTG HOLE
15 (.59) deep
8-M3.5
SCREW
When mounting, no extra space is needed between units.
13 (.51)
Connector of
Sensor Cable
̒
■
CURRENT PROBE
Mount the sensor so that the conductor passes near the
center of the sensor and at right angle to the sensor circle.
Otherwise, the position sensitivity may increase.
In order to separate the connection, pull out the sensor end
from the connector.
Use binding straps for fixing the position of the probe with
the attachments.
