M-E VDV-907, Operating Instructions Manual

Page: 45 / 104

ENGLISH | VDV-907
46
GB
Changing the coding of the radio protocol
(CUVEO and BELL)
If the CUVEO receiver and/or the BELL recei-
ver activate for no reason, another transmit-
ter in the vicinity could be transmitting the
same code. To change the code, proceed as
follows: The monitor must be in standby.
Hold a finger on the mute button (approx.
7 seconds) until the key and mouth symbols
light up.
Then all receivers (CUVEO and BELL) must
be relearned.
TECHNICAL DATA
Operating voltage: 15Volt DC
Power consumption: 270 ± 50mA
Frequency WLAN: 2.4GHz; <100mW
Frequency BELL: 434MHz; <10mW
Temperature range: 0-50°C
Max. humidity: 85 %
Screen diagonal: 178mm
Monitor resolution: 1024x600
Dimensions: 220x160x28mm (W x H x D)
NOTES
Exposure to strong static, electric or high-fre-
quency fields (discharges, mobile phones,
radio equipment, mobile phones, microwa-
ves) may impair the function of the equip-
ment (the appliance).
Cleaning and care
Disconnect mains operated units from the
mains (pull out the plug) before cleaning. The
surface of the housing can be cleaned with a
soft cloth moistened with soapy water. Do
not use abrasive cleaners or chemicals.
Loosen dust deposits on ventilation slots
only with a brush and, if necessary, vacuum
with a hoover. Do not hold the suction nozzle
directly against the unit.
Legal principles
1. As the operator or user of the video door
unit, please observe the regulations and
legal principles of your country for the use
of surveillance devices with regard to
personal rights and data protection!
2. In many countries, video images and/or
speech may only be transmitted after a