M-E VDV-907, Operating Instructions Manual

Page: 44 / 104

VDV-907 | ENGLISH
45
GB
On the next page you will find the links to the
Android and iOS app, as well as further infor-
mation on operating the app.
Information about the indoor unit
Touch the information symbol. The operating
voltage of the indoor unit is displayed here in
volts. It should be between 15V and 15.5V. The
IP address of the indoor unit is also displayed.
Deleting all pictures
Touch the dustbin symbol if you want to
delete all saved pictures. Touch the green
highlighted field there and confirm the follo-
wing dialogue with "Ok" to delete all pictures
or touch "Cancel" to cancel the deletion pro-
cess.
Reset
Touch Reset to reset the indoor unit to fac-
tory settings, e.g. if you have forgotten the
access data for the app.
Touch the green button and confirm the reset
by tapping "Ok" in the following dialogue.
Please note that photos are not deleted by a
reset.
Coding the BELL receiver
Tap on the BELL symbol to access the set-
tings menu for the radio chime. Put the recei-
ver into learning mode by pressing the code
button until the receiver beeps briefly and
then tap one of the letters on the monitor.
The receiver plays a melody and is ready to
be learned.
Setting the melody of the radio chime
Tap on the BELL symbol to enter the settings
menu for the radio chime. There you have the
option of deactivating the integrated radio
module and changing the melody of the
radio chime. Tap on a letter, the taught-in
radio chime plays the corresponding melody.
This melody is immediately saved and you
can exit this menu using the back arrow.
Coding the CUVEO receiver
Put the receiver in the learning mode (press
the button on the receiver until the LED on
the receiver flashes) and activate the monitor
by tapping on the touch-active surface. then
tap on the light symbol. If the light symbol is
not displayed, check whether it is activated in
the basic settings (B5).