M-E FS-2 V2, Operating Instructions Manual

Page: 11 / 28

ENGLISH | FS-2
V2
11
NOTE : When using the device as a babyphone, position it at
least one meter away from the child.
EXTERNAL SPEAKER
A headphone or a powered speaker can be connected to the
3.5mm connector (2). This is particularly useful in noisy
surroundings or when using the device as a paging system
in halls.
To charge (using the separately available lithium-ion battery
pack) To charge the internal lithium-ion battery, connect
the supplied power adaptor to the radio communication
system. To do this, insert the plug of the adaptor in the “6V”
(1) socket. The battery is charged even when the device is
switched off. If the battery is completely flat, charging takes
about 4 hours.
TROUBLESHOOTING
Device does not switch on >> Battery flat > Connect the
adaptor to the device and charge the battery
Device switches on but does not establish a connection to
the other device >> incorrect channel set > set the same
channel on all devices
Device malfunctions >> Micro controller hanging > press
Reset key in battery compartment
Should this not solve the problem, please contact our service
technicians.
To select the ringtone and ringtone volume
To select a ringtone, unscrew the battery compartment,
where the “TONE” (19) key is located. Press the separately
available battery into the battery compartment using your
thumb or connect the power adaptor to keep the device
live. Using the “TONE” (19) key, select a ringtone from the
range of 5 ringtones available. The tone selected last will be
retained even when the battery is removed. Set the ringtone
volume to one of the three levels available, using the sliding
control (20) in the battery compartment. When you are
satisfied with your settings, screw the battery compartment
down again.
INTERCOM FUNCTION
Press and hold the key “ ” (9) whilst you are talking.
Release the key to allow your device to receive. The LED (15)
also displays this status.
HANDSFREE FUNCTION VOX
To activate the handsfree function VOX press the “VOX” (10)
key once. As long as “VOX” flashes on the display, you can
set the sensitivity to 4 levels using the keys “+” (11) and
“-“ (5). A single line in the display means lowest sensitivity,
4 lines mean highest sensitivity. Wait until “VOX” stops
flashing in the display. The blue LED “VOX” remains lit up.
When the device detects a sound, e.g. your voice, a baby
crying etc., it automatically starts transmitting and the LED
(15) lights up red. Transmission stops as soon as no sound
is detected.
To deactivate the handsfree function, briefly press the “VOX”
key twice in quick succession, the blue LED “VOX” switches
off and “VOX” disappears in the display.
FS-2 V2 150x180 Fin2.indd 11 29.10.20 14:28