5.
Mark the holes with a pencil and put the housing part aside.
6.
Drill the holes at the marked points with an appropriate drill bit.
7.
Insert one of the dowels supplied into each hole and then screw the rear part of the housing to
the mounting point using the screws provided.
8.
Reassemble the radio bell push button and screw the housing together with the two housing
screws.
TECHNICAL DATA
Power supply:
1x 3 Volt lithium battery type CR 2450
Power consumption:
7.0 mA during transmission
0.003mA in idle state
Frequency and transmission power:
434MHz / <10mW
Operating temperature:
-15°C - + 45°C
Ringing melodies:
8 ringing melodies
Coding:
256 digital codes
WARRANTY
This product is warranted to be free from defects in materials and workmanship for a period of 2
years from the date of purchase. This only applies if the product is used in the usual manner and is
regularly maintained. The obligations of this warranty are limited to repair or reinstallation of any
part of the equipment and are only valid on condition that no unauthorised modifications or
attempted repairs have been made. Your statutory rights as a customer are in no way affected by
this warranty.
Please note:
There is no claim under the warranty in the following cases, among others:
•
Operating error
•
flat batteries or defective accumulators
•
wrong coding/channel selection
17
BELL-401 / BELL-402
EN
Summary of Contents for BELL-401 TX
Page 2: ......
Page 35: ...35 BELL 401 BELL 402 ...
