M-B ZTB, Operator And Parts Manual

Page: 14 / 30

12
Publication: ZTB-080112
M-B Companies, Inc. 11/14/12
iNTRODUcTiON ASSEMBLy
Electric (Optional)
a. Place the glide ring on top of the mounting flange. Line up the
bolt holes.
b. Place the discharge chute on top of the glide ring. the teeth
in the plate will not contact the electric drive. Rotate the chute
so the discharge is facing forward.
c. Place the gear plate for the electric drive over the top of the
chute. Lower it until it is flat and the teeth engage the electric
drive. Some adjustment may be needed to have all the bolt
holes line up. Insert 5/16 carriage bolts through the four pairs
of mounting holes.
C
A
B
Figure 12
d. Position one of the upper slide (narrower) pieces onto the
bolts.
e. Position one of the lower slide pieces onto the bolts.
f.
Secure with a flat washer and a locking nut.
D
E
F
Figure 13
g. When all four slides are installed, the chute should be able to
rotate smoothly but should not be a loose fit.
h. Position the actuator as shown and bolt it to the plate.
i. Attach the plate to the side of the chute opening.
j. Connect the electrical plug to the wiring harness from the
control box mounted to the handlebars.
H
I
Figure 14
The assembly is complete.