2
Features
<
Front panel balanced XLR mic input with switchable phantom power and dedicated gain control
<
Front panel unbalanced guitar/instrument 1/4” input with dedicated gain control
<
Switchable rear panel unbalanced 1/4” line inputs
<
Rear panel balanced/unbalanced 1/4” TRS outputs with level control
<
Rear panel coaxial S/PDIF I/O.
<
Front panel headphone output with level control
<
Versatile mixer/router control panel provides near zero-latency hardware direct monitoring.
<
Extremely low-latency hardware/drivers.
<
Kensington lock port for security
<
Two 6-pin FireWire ports.
<
Cool blue indicator LED.
<
Bus-powered (six-pin FireWire connection required) or powered via included PSU.
<
Frequency response from 20-40kHz
<
Dynamic range of 102dB
<
Supports sampling rates of 44.1k, 48k, 88.2k, and 96kHz
Mounting the device to a rack drawer
Holes are located on the left and right of the bottom of the FireWire Solo, to allow you to mount this device to a rack tray. The FireWire Solo is
mountable on either the left or right side of the drawer. If you choose to mount the device to a rack tray, you must first remove the rubber pads
from the base of the unit.
Minimum System Requirements
Windows
<
Pentium III – 500 MHz or higher
<
128 MB RAM
<
Windows XP (SP2) with DirectX 9.0b or higher
<
Onboard FireWire connection or installed FireWire PCI card
The FireWire Solo is not supported under Windows 98, Windows ME or Windows 2000.
Mac OS
<
Macintosh G3/G4* 500 MHz or higher
<
OS X 10.2.8 or later, 256 MB RAM or
<
OX X 10.3.5 or later, 512 MB RAM
<
Onboard FireWire connection or installed FireWire PCI card
*G3/G4 accelerator cards not supported
OS X 10.3.5 or later required for Dolby Digital and DTS pass-through with Apple DVD player.