Page 6 of 16
75.5947.04 LZR-FLATSCAN SW 20200612
Page 6 of 16
75.5947.04 LZR-FLATSCAN SW 20200612
2
1
3
5
7
2
4
6
Cut the power cable to the correct length, strip the 8 wires, and connect all wires as
indicated above.
Determine the appropriate length for the door
loop.
Cut excess door loop to avoid obstructions.
Pass power cable through door loop and connect
white plug to white connector.
Ensure that the
loop does not interfere with the sensor view.
Create a loop with the wires of the power cable
and pass them through the notch as indicated.
Use the other part of the cable to block the
wires.
Secure the door loop to the sensor, using the
clamp. Secure the 2 screws to avoid pulling out
the cable.
Tighten the other side of the door loop using the
cable cap and pass through the remaining length
of the power cable towards the door controller.
REMOVE WINDOW
PROTECTOR
WIRING
LZR-FLATSCAN SW
+
-
RED
BLACK
BLUE
BROWN
GREEN
WHITE
PURPLE
PURPLE
**
Output status when sensor is operational (can be NO or NC)
*
If only VAC power is available, a 12V transformer paired with a rectifier must be used.
Do not use a 24V transformer and rectifier as this will cause damage to the product.
POWER SUPPLY
TEST
STOP IMPULSE
Opening side of the door
REOPENING IMPULSE
Closing side of the door
RELAY 1
RELAY 2
**
**
12-24 VDC*
COM
NO/NC
COM
NO/NC
