LX-F6
LYNX Pro Audio S.L. -
Valencia, Spain -
www.lynxproaudio.com - [email protected]
With classic configurations, the higher cabinets have the task of covering the area furthest away, thus needing the
“Long Throw” preset. Remember you must enter this preset in to every cabinet that requires this configuration.
Choose the configuration which meets the needs of your installation. If you do not need to make any further changes
press OK until the progress bar finishes. The display will indicate “Loading DSP”.
MANUAL MODE
By selecting Manual mode, the system does not take in to account the number of boxes or the inclination, and uses
the factory equalization parameters, crossover and dynamics. This enables you to manually correct the system with
an external processor if the configuration is not common or you desire a different type of adjustment other than that
supplied by the factory.
AUTOMATIC MODE
In this mode the cabinet will read the inclinometer information upon Start up and then apply the corresponding preset
according to the inclination of the cabinet. This only happens when the cabinet is switched on and will last until the
next reading which will be when the power is taken up again. This is done to anticipate movements such as wind
causing variations of the inclination and changing the configuration when not desired.
Average values have been taken to detect the angulation and apply different throw presets based on the most typical
configurations:
- If the cabinet has between
0º and –13º
The
Long Throw
preset will be applied.
- If the cabinet has between
–13,1º and –21º
The
Mid Throw
preset will be applied.
- If the cabinet has between
–21,1º and –90º
The
Short Throw
preset will be applied.
Note: If positive degree values are detected, the DSP
Long Throw
preset will be applied.
16
Summary of Contents for LX-F6
Page 43: ......