Lynx DSX-1004, User Manual

Page: 22 / 61

22
DSX
4 - EDITING WITH DSX
Output configuration buttons.
ROUTE: Clicking on this Icon you will be able to select from which of the inputs that channel will take the
signal. Options are A, B, A+B, C, D and C+D (ARK 44 and 48)
XOVER (Crossover). Access to the configuration window of the Crossovers where we can set up filters of
each Output. It has Linkwitz-Riley, Bessel and Butterworth filters of 2nd, 4th, 6th and 8th order. It is also
possible to leave them in Bypass and have a full range of output.
PEQS (Equalization). We entered in the parameters of equalization of each Output. We have 9 per output
fully configurable filters or selectivelly Bypass, parameters: (Q constant or adaptive), Shelving of low and
high frequencies of 6dB/oct and 12dB/oct (with or without Q), and lowpass HiPass (with and without Q ),
Bandpass, Stop Band and AllPass first and second order. With them you can equalize each one of the
outputs separately or link between them.
Gain: Pressing the "E" button, you will access the Main Gains window. From here you will be able to
adjust the Gain on each input and output. You can also Mute , invert the Polarity or activate the "Solo"
mode. You are also able to do all this from the Main Window .
DELAY . Allows you to set delays for each Output. For each main output you have 20.81 milliseconds to be
used in the alignment of the boxes of a system or inside a box itself and correct the gap by not being in the
same vertical plane.
DYNAMICS . It will let you adjust the parameters on the RMS Limiter and/or Peak Limiter. From here,
you can apply protection to your speakers and/or apply Noise Gates on each output. In order to access
the parameters window you will have to press the corresponding button;
RMS Dynamics or PEAK
Limiter.
FINAL FREQUENCY RESPONSE . In this screen you will be able to see the final frequency response after
all the settings have been applied. You will see the effect of applying different filters, gains and also see the
Phase obtained. You also have the capability of
import Frequency response from measure softwares
such as CLIO, MMLS, Smaart Live etc, to apply correction with the filters of the processor till you obtain
the desired ‘best’
electroacoustic response .
Additional Info . It gives access to General Info window, where you can input the name of the system
which you are working on, Sound Engineer name, Project or venue name, or comments.
Copy . This utility lets you choose between parameters of each output to copy them between the channels
that you want, In case you want the same parameters in two or more channels.