2.03 Part Guard Arming Option 1
PART GUARD means that the system is only armed in pre-set zones, allowing you to oc-
cupy or pass through the unarmed zones. This is normally used for night-time setting of the
alarm system to isolate the bedrooms.
Enter a Valid User Code and press SET within
3
seconds.
Example:
Enter:
System Ready
Melcom
?
?
?
?
Part Arming
System Armed
PART GUARD mode will become armed within 5 seconds (or
the time programmed by the engineer). You should leave or go
to a non-armed part of the building, zone LEDs, PA and Tam-
per will flash momentarily to indicate Part Guard Arming.
Note: If you have zones programmed as Sleep Watch zones, these can only be
armed after Part Guard arming and pressing the sleep button on the sleep watch
remote keypad.
2.04 Omitting Zones Full Guard
You might wish to omit zones in full guard before arming the system. For example, you can
omit the zone that protects the garage.
SET
Enter a valid user code and press OMIT, enter zone number to be omitted and press
OMIT.
Enter: 1
?
?
?
?
Press: OMIT
2
Press: OMIT
System Arming
Omit Zones
2
System Arming
Zones omitted will be reintroduced to the system once the system has been disarmed. If
you wish to have a zone disabled from the system, you must contact your installation
engineer.
Note: PA, Tamper, Fire Zones & 24 Hour Zones can not be omitted.
6
Example: Omitting zone 2
