Lyngdorf MP-50 – External Control Manual
18
Controlling Focus Positions
Command !RPFOCS?<CR> is used to get the list of selectable focus positions along with
their names. For example, a response for !RPFOCS<CR> could be:
!RPFOCCOUNT(4) <CR>
!RPFOC(1)"Focus 1"<CR>
!RPFOC(2)"Focus 2"<CR>
!RPFOC(4)"Focus 4"<CR>
!RPFOC(9)"Global"<CR>
It can be seen from the response that there are 4 RoomPerfect positions, named “Focus 1,”
“Focus 2,” “Focus 4,” and “Global.” Note that the numbering of the positions is not
consecutive.
Command !RPFOC?<CR> is used to find out which position is currently selected. The
response for this command is !RPFOC(X)”NAME”<CR> where X is the index of the currently
selected position (a value between 0 and 9) and NAME is the name of the currently selected
position. This response is sent automatically whenever the position is changed if feedback
level is 1 or higher.
Commands !RPFOC+<CR> and !RPFOC-<CR> are used to select next or previous position.
Command !RPFOC(X)<CR> is used to select a specific position. The X in the command can
be any index from the list of measured focus positions retrieved by using command
!RPFOCS?<CR>.
The installer might add or remove focus positions at any time, so it is recommended to
update the list of selectable focus positions at least in every boot-up.
