LyngBox HDTV receiver, Manual

Page: 16 / 24

7.7 E-mail Settings
Displays your LyngBox e-mail address and e-mail configuration.
7.8 TV Reception & Channel Search
This menu holds all menus for configuring satellite equipment and performing channel search. Installation and updates of
channels are normally taken care of automatically by the LyngSat Maps service, but can be further tweaked or managed
completely manually.
7.8.1 Antenna Configuration
This menu is used to configure the equipment used for satellite reception.
The dish size and signal strength threshold for LyngSat Maps can be configured
by pressing [blue]. This is usually set in the installation wizard, but can also be
altered here.
Specify what kind of DiSEqC equipment that is used (none/2-way/4-way/
motorized antenna/other)
a. DiSEqC switch: Specify LNB type and satellite for each port
b. Motorized antenna: Specify satellite for each motor position.
Rotate the motor using [red] and [green] to find the correct satellite
positions. When a satellite position has been identified, select index for storage in the motor and press [blue] to save
the position. Alternatively predefined motor positions can be used. Select an index and press to rotate
the motor to this position, next select satellite. Position is automatically saved. Rotation boundaries can be defined in
the advanced menu, accessible with [yellow].
1.
c. Other: Can be used to define up to 64 LNBs. See the figure below for guidance.
i. P: First four port DiSEqC switch
ii. 1: Two port unallocated level one switch (SW1)
iii. 2: Two port unallocated level two switch (SW2)
iv. 3: Two port unallocated level three switch (SW3)
v. 4: Two port unallocated level four switch (SW4)
Specify what kind of LNB that is used. Regardless of LNB type, a +1V offset can be set for each LNB to compensate for
long cables, press [yellow] to configure the offset.
a. KU-band Universal
b. C-band Normal
c. C-band Extended
d. Other: User defined local oscillator (LO) frequency and spectrum invert. Press [yellow] to define values.
Associate each LNB with a specific satellite. For motorized antennas each motor index has to be associated with a satellite
position.
2.
3.
31 30
1
2
3
4
P
SW1
A
B
SW2
A
B
SW2
A
B
SW3
A
B
SW4
A
B
fig. 11
fig. 12