Master Section
17. AUX1 AUX2
This rotary control adjusts the level of signal sent for, the auxiliary bus to the auxiliary
output. For optimum performance this should be set to around 7or 8 on the scale, and
the input level often effects unit being fed from the aux output should be adjusted to
operate with this level of signal.
18. AFL
Pressing this after fader listen switch routes post-fader (i.e. LEVEL control) signal form
the aux master to the headphone monitor outputs on the front and rear panels of the
console. At the same time all other signals are automatically disconnected form the
monitor section, allowing the A Fled signal to be listened to in isolation.
19. P48V
This slide-switch turns the master phantom power on and off. 1-2, 3-4 is applies 48V
DC across I-2 and 3-4 each microphone input channels connectors for remote powering
of condenser microphones.
20. OUTPUT MASTER FADERS
LEFT/RIGHT
This is a master fader for adjustment of
volume of right/left output.
21. SUB1/SUB2
Using by this control, you can adjust SBUI,
SBU2 outputs level.
