Input Module
10. MAIN
This switch routes signal form the channel to the
stereo masters
．
The relative amounts of signal sent
to the left and right is determined by the position of
the PAN pot
．
When the switch is depressed signal
from the channel is sent to masters
．
11. SUB
This switch routes signal firm the channel to output
groups 1 and 2
．
The relative amounts of signal sent
to the two groups is determined by the position of
the PAN pot
．
When the switch is depressed signal
from the channel is sent to groups l and 2
．
When the
switch is in the raised position the signal feed to
groups 1 and 2 is disconnected
．
12. PFL
Pressing this Pre-Fader listen switch routes
pre-fader signal from the channel to the headphone
monitor outputs on the front and rear panels of the
console
．
At the same time all other signals are
automatically disconnected from the monitor
Section, allowing the PFL signal(s) to be listened
to in isolation
．
This feature allows the operator to
listen to a signal on the headphone
．
checking that it
is dean and undistorted
．
before fading the signal up
．
13. FADER
The channel fader is a 60mm travel audio fader
．
Is
adjusts the level of signal sent from the channel to
the groups, stereo masters
．
To allow the optimum tangle of control the fader
should be run close to the O position on the
scale
．
The input GAIN control should be set to allow
this
．
