Rev #2
Version 3.00
August 2020
Page 38 of 80
6.8.1
QNH
QNH settings can be changed in this menu. If the QNH setting is correct the NANO
4
will
show the correct altitude. This is the same page that also appears on power-on. This can
be disabled by unchecking the
Show dialogue
option.
A wrong QNH setting will have an effect only on wrong altitude warnings and a
wrong final glide calculation. The QNH setting has no influence over the recorded
altitude in the IGC file.
6.8.2
Flight Recorder
Pilot's information and glider data can be configured in this menu:
•
The
Pilot's
name must be entered here.
•
The
Co-Pilot's
name must be entered here, if glider is a double seater.
•
The
Competition sign (callsign / number)
of the glider.
•
The
Registration number
of the glider.
•
The
Recording interval
sets the interval when the GPS position is stored in flight.
•
Auto Finish
will allow the automatic finish of the flight under certain conditions.
Uncheck this item for wave flying (ground speed is used to indicate the end of a flight
and in wave it is possible to be stationary or even fly backwards in relation to the
ground).
•
When
Auto power Off
is enabled it power off the NANO
4
30 minutes after the flight
is finished.
•
Always on
will force the recording/write position to an IGC file immediately after
power on. Normally the NANO
4
logger is triggered by a ground speed exceeding
40 km/h or a vario exceeding 1 m/s. Hang glider pilots are advised to use this
function.
•
The
Pilot's weight
•
The
Co-pilot's weight
•
Enable MOP recording
is advised to be used when using a NANO
4
for JET gliders.
This setting can be changed only when flight recorder is not running (Is Stopped).
