a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450
User Guide
17
DHCP Client:
Enabled or Disabled. DHCP (Dynamic Host Confi guration Protocol)
is used to automatically assign an IP Addresses to a device on the network. If
DHCP is enabled on the Access Point, it will no longer use the static address set
by Luxul at time of manufacturing and will request a dynamic IP Address from the
Router (sometimes referred to as the Gateway).
When DHCP is enabled on the Access Point, the new IP address will be needed
in order to access the web management interface. The Router web interface can
be used to look up the IP address assigned to the Access Point. To Enable DHCP,
click on the drop down menu and select
Enable
. Select
Apply
and then
Reboot
for the change to take effect.
NOTE:
DHCP is set as
Disabled
by default and is the recommended
setting in order to ensure optimal communications with all Luxul
devices on the network.
IP Address:
An IP address is a numerical label assigned to each device on the
network. This fi eld shows the IP address that is assigned to the XAP-1010. To
ensure plug and play capability with other Luxul networking products, the IP
Address is automatically defaulted to 192.168.0.10. If desired, the user can set
this to a different static IP Address. To change the IP address of the Access
Point, simply type in the desired IP address (the text fi eld will be red if the
address is incomplete), click
Apply
and then
Reboot
for the changed to take
effect. When connecting to the Access Point through the web interface, the
NEW
IP Address must be used.
NOTE:
Each device on the same network must have a unique IP address.
If the Access Point is assigned an IP address already in use, it
will result in an IP address confl ict that will need to be resolved
manually. For optimal communications with all Luxul devices on
the network, it is recommended that IP addresses not be changed
unless absolutely necessary.
Subnet Mask:
To ensure plug and play capability with other Luxul networking
products, the Subnet Mask is automatically defaulted to 255.255.255.0. If desired,
the user can set this to a different static Subnet Mask.
