English
- 80 -
Side AV Input
Audio Cable
(Not supplied)
Side Video/Audio
Connection Cable
(Supplied)
SI
D
E
AV
YPbPr
Side view
DVD Player
Connection Cable
(supplied)
YPbPr Video Cable
(Not supplied)
When the connection is made, switch to
•
YPbPr
source. See,
Input selection
section.
Note:
To connect Y Pb Pr device, you should use
supplied component (YPbPr) connection cable
You may also connect through the
•
SCART
input.
D
I
H
M
1
SPDIF
Coax.OUT
D
I
H
M
2
Scart
Cable
(not
supplied)
External device
Note
•
: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of
•
the handset by gently pulling backwards from the
indicated part.
Insert two
•
AAA/R3
or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note
: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC
•
50 Hz.
Switch the
•
“
”
button to position “
|
” so the
TV will
switch to standby mode
. Then the standby
LED lights up.
To switch on the TV from standby mode either:
•
Press the “
•
” button,
P+
/
P-
or a numeric
button on the remote control.
Press the
•
-P/CH
or
P/CH+
button on the TV.
The TV will then switch on.
Note
: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
To Switch the TV Off
Switch the “
•
” button to position 2 as illustrated,
(
) so the TV will switch
OFF
.
•
To power down the TV completely, unplug the
power cord from the mains socket.
