Fast cleaning instructions
In order to clean the dirt separator filter rapidly, follow the below instructions:
Turn off the boiler using the switches or knobs of the control panel and remove the boiler's plug from the power socket.
Isolate the dirt separator filter from the heating system by closing both the valves upstream and downstream of the filter in
order to avoid the emptying of the whole heating system.
Remove the transparent bottom plug and take the magnet out of its housing.
Unscrew the plastic threaded end cap (WARNING: circuit under pressure) and collect all the liquid and accumulated
impurities in a container.
Replace the plastic threaded end cap with its rubber gasket.
Put the magnet into its housing again and insert the transparent plug.
Slightly open the ball valves upstream and downstream of the dirt separator filter which have been previously closed.
Adjust the pressure of the heating system water in compliance with the working pressure limit values indicated by the
boiler's manufacturer.
Annual cleaning instructions
In order to carry out the annual cleaning operations, removing the magnet and the metal mesh, follow the instructions below:
Turn off the boiler using the switches or knobs of the control panel and remove the boiler's plug from the power socket.
Isolate the dirt separator filter from the heating system by closing both the valves upstream and downstream of the filter in
order to avoid the emptying of the whole heating system.
Remove the transparent bottom plug and take the magnet out of its housing.
Unscrew the plastic threaded end cap (WARNING: circuit under pressure) and collect all the liquid and accumulated
impurities in a container.
Unscrew the lower body and wash it with running water.
Remove the metal mesh and wash it with running water.
Remove the ferrous impurities which may have accumulated in the filter.
Replace the metal mesh and the lower body with rubber gasket screwing it to the upper body.
Replace the plastic threaded end cap with its rubber gasket.
Put the magnet into its housing again and insert the transparent plug.
Slightly open the ball valves upstream and downstream of the dirt separator filter which have been previously closed.
Adjust the pressure of the heating system water in compliance with the working pressure limit values indicated by the
boiler's manufacturer.
Once the fast or annual cleaning have been completed, the heating circuit needs to be emptied of any air in excess.
An accurate maintenance always enables saving and security.
DANGER
Danger of burns due to hot water. Never open the dirt separator filter while the boiler is working and the circiut is under
pressure.
Danger of flooding, before disassembling the dirt separator filter, make sure that both the ball valves upstream and downstream
of the dirt separator filter have been closed.
FORBIDDEN
Before cleaning the dirt separator filter, turn off the boiler and disconnect it from the power supply.
Do not block or reduce the openings for the flow of the heating circuit water.
PRESENCE OF MAGNETIC FIELDS
Please note that there are strong magnetic fields which can damage or interfere with the correct functioning of electronic
devices (pacemaker, magnetic badges, etc.).
