Operating Instructions
The installation must be carried out by professionally qualified people and in compliance with the manufacturer’s
instructions.
Before installing the dirt separator filter, make sure that the heating circuit or the boiler are provided with a relief valve set
at 3,0 bar.
It is very important to pay attention to the dimensions and the features of the dirt separator filter indicated above before
proceeding with the following installation steps.
Below you can find useful information for the correct installation of the magnetic dirt separator filter:
1)
Check if the hydraulic connections and the technical data of the system allow the installation of the magnetic dirt
separator filter.
2)
Disconnect the boiler from the power supply (in order to avoid dangerous accidents and damages to the circuit board).
3)
Empty the system and wash the heating circuit pipes.
4)
The magnetic dirt separator filter has to be installed in an accessible place where all the future maintenance and
periodic cleaning operations can be easily carried out.
5)
During installation make sure that the flow directions (inlet / outlet) are respected.
6)
It is recommended that shut-off valves are installed upstream and downstream of the dirt separator filter in order to
facilitate maintenance operations.
7)
Before applying pressure to the dirt separator filter make sure that the plugs and the upper and lower bodies are
tightened.
8)
Insert the magnet in its specific housing and place the transparent bottom plug.
9)
After 10 minutes working, stop the system and check if the cover is well blocked and tightened.
WARNING
All maintenance work must be carried out when the heating circuit is cold and by professionally qualified staff: the periodicity of
the dirt separator filter's maintenance is twice a year. A use of the dirt separator in accordance with its intended use means also
observation of the maintenance instructions. After the first installation, it advisable to remove the dirt accumulated in the filter
twice a week during the first month of use.
