WARNING:
BE CAREFUL WHEN INSTALLING THE DECORATIVE CHIMNEY AND HOOD, THEY MAY HAVE SHARP
EDGES.
CAUTION:
DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE DECORATIVE CHIMNEY
INSTALLATION OF THE UNIT
Install 6" round adapter/damper on top of the hood using 4 no. 8 x 7/16" mounting screws.
Align the hood and center it above the hood mounting bracket. Gently lower the hood until it
securely engages the bracket.
With the hood hanging in place, drill through both holes located at the back of the hood using
a 5/16" drill bit (Fig. 2).
Insert the included drywall anchors into the drilled holes (one for each hole). Insert 2 no. 8 x
1¼" mounting screws in 2 washers, then insert into the drywall anchors. Verify that the hood is
centered and leveled. Tighten all screws completely.
Remove protective plastic film covering the lower chimney only.
If possible (when space is sufficient): Install the lower chimney bracket to the chimney using 2
no. 8 x 7/16" mounting screws, ensure that the slots point up (Fig. 3).
Carefully place both chimneys on top of the hood. NOTE: Slightly slide up the upper chimney to
avoid damaging it.
Slide a 6" metal round duct over the adapter/damper (Fig. 2). Use metal foil duct tape to seal
the joint.
Plug hood power cord into the outlet.
Slide up the upper chimney until it is aligned with its mounting bracket. The bracket must be
inside the chimney. Secure the upper chimney to its bracket using 2 no. 8 x 7/16" mounting
screws (Fig. 4 and 5).
Remove protective plastic film covering the upper chimney and the hood.
Fig.1
Fig.2
Fig.3
L
OWER CHIMNEY MOUNTING BRACKET
B
ACK VIEW
L
OWER CHIMNEY
