Luxair LA-350, Installation Manual, Page: 7 / 17

External Push button for sensor (PS).
Activation/deactivation of the automatic function:
■
Make sure that the motor is off before the push button is pressed.
■
Press the push button: if 4 acoustic signal are issued the automatic function is
activated.
■
Press the push button: if an acoustic continuative signal is issued, the automatic
function is deactivated.
If the push button is pressed with running motor, it switches off the motor and the
sensor is for 20 minutes without function.
MAINTENANCE
METAL FILTERS
The metal filters are used to retain the particles in suspension.
For washing by hand, use hot water and soap; this can be done by hand brushing
vigorously several times and then rinsing under the tap.
After washing, the metal filters should be dried and re-fitted correctly.
It is possible that after washing the filter will have slight change in the colour.
It is advised to wash the metal filters after circa 100 hours of use of the
appliance.
If the metal filters are very dirty, the motor can only take in a small quantity of air, and
performance is reduced.
CLEANING
To preserve the apliance in good condition, clean this periodically following the advice
given as follows.
Make sure that power has been completely turned off.
The detergent solution recommended is a combination of WATER and NEUTRAL LIQUID
SOAP. It is of vital importance that the liquid soap should not contain any grains which
could scratch the surface.
The solution should be applied first onto a soft cloth which is then rubbed over the shell.
It is important to follow the pattern of the satin finish with the cloth.
It is absolutely forbidden to pour liquids directly onto the appliance.
The cloth used should not have any buttons, zips, fasteners or anything else which could
scratch the surface.
The use harsh abrasive or granular products, petrol, spirits or similar products which
could damage the surface of the materiall, is severely forbidden.
The manufacturer will not be responsible for any damages either functional or to the
appearance of the hood, caused by cleaning operations carried out using unsuitable
products or unsuitable methods.
8