Lux Tools 468273, Original Operating Instructions, Page: 10 / 28

10
GB
Unpacking and assembly
Unpacking
Unpacking the device and checking for complete-
ness.
Scope of supply
Assembly
Assemble protective housing.
Figure 2 – Page 4
– Insert the protective shield (8) and tighten it on
the device with the screw (9).
– Remove transport protection from cutting
knife (10).
Attaching the cord head
Figure 2 – Page 4
– Tighten cutting head (A) on the device.
Mount front handle
Figure 3 – Page 4
– Tighten front handle (5) using the fixation
screws (11) on the upper end of the product.
Put screwdriver together
Figure 4 – Page 4
– Plug shaft pipe (7) in the latch for the product
part (6) until locking pin (12) is locked.
– Attach the shaft pipe (7) using fastening
screw (13).
Attach carrier belt
Figure 5 – Page 4
– Hook eyelet of carrier belt (4) into the hooks (14)
as illustrated.
Using for the first time
Check before starting!
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
– Check that the safety devices are in faultless
condition.
Operation
Correct posture
Hold the device
• with the left hand on the front handle;
• with the right hand on the operating handle at
approx. hip height;
• balanced in a comfortable position.
Switch product on/off
Figure 6 – Page 4
– Hold the product firmly in both hands.
– Keeping the switch-on safety lock (3) pressed,
press the on-off switch (2).
• Instructions for use
• Lawn trimmer • Cutting tool
• Protective shield
Instruction: If a part is missing or dama-
ged, please contact the vendor.
WARNING! Risk of injury! Place the pro-
duct horizontally on a stable, sufficiently
load-bearing and level surface.
WARNING! Risk of injury! Parts may only
be assembled and disassembled when
the motor is switched off and has cooled
down.
WARNING! Risk of injury! On the under-
side of the protective hood there is a
sharp knife for cutting off the cord. Only
remove the transport protection after
assembly.
WARNING! Risk of injury! On the under-
side of the protective hood there is a
sharp knife for cutting off the cord. Only
remove the transport protection after
assembly.
WARNING! Risk of injury! The product
must only be put into operation if no
defects or errors are found. Ensure that
any defective parts are replaced before
the product is used again.
WARNING! Risk of injury! Before begin-
ning work, check the terrain and remove
all objects that may be flung out by the
product.
WARNING! Risk of injury! Switch off pro-
duct, if:
• The cutting tool has come into con-
tact with solid objects;
• Changes in the behaviour of the pro-
duct are noticeable;
• The sound of the motor changes.
Check the product and have it repaired if
necessary. Never work with a damaged
device or cutting tool.
468273_Trimmer_Elektrisch.book Seite 10 Dienstag, 10. November 2015 10:54 10