Lux Tools 301 393, Original Instructions Manual

Page: 8 / 20

8
– Turning the speed controller (1) towards [Max]
increases the speed.
– Turning the speed controller (1) towards [1]
reduces the speed.
Sanding
– Clamp in the workpiece or hold it firmly.
– Switch on the product and press it against the
surface to be sanded applying even pressure.
Cleaning
Cleaning at a glance
Regularly, depending on the conditions of use
Empty the dust container
►
P. 4, item 3
1. Press on the upper side of the dust collector as
shown.
2. Pull the dust collector fully away from the rear of
the device.
– Remove the lid (7) from the dust collector.
– Empty the dust container.
– Re-install the dust container in reverse order.
Pay attention to the correct position of the filter
mat.
Troubleshooting
If something doesn’t work…
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting your
local dealer. You will save yourself a lot of trouble
and possibly money too.
If you are unable to remedy the fault yourself, please
contact your local dealer. Please be aware that any
improper repairs will also invalidate the warranty and
additional costs may be incurred.
Disposal
Disposal of the appliance
Appliances which are labelled with the adja-
cent symbol must not be disposed of in
household waste. You must dispose of such
old electrical and electronic equipment sep-
arately.
– Please check with your local authority about the
possibilities for correct disposal.
Through separate disposal you send old equipment
for recycling or for other forms of re-use. You will
thus help to avoid in some cases that damaging
material gets into the environment.
Disposal of the packaging
The packaging consists of cardboard and
correspondingly marked plastics that can
be recycled.
– Make these materials available for
recycling.
NOTICE! Risk of product damage! The
motor can overheat if continuously run
under heavy load and at low speeds. If the
motor has been run at elevated speed,
allow it to cool by idling.
DANGER! Risk of death through electric
shock!
Only use the product for dry sand-
ing.
WARNING! Danger of fire! Do not use a
dust container when sanding metal! Hot
metal particles can ignite the material of the
container.
Note: When working on vertical surfaces,
hold the product such that the dust con-
tainer faces downwards.
Note: Excessive imprints do not lead to
increased sanding performance, but leads
to increased wear of the product and the
sanding disc.
DANGER! Risk of injury! Before all work
on the device, disconnect the mains plug.
What? How?
Clean dust from the mo-
tor’s ventilation slots. Use a vacuum cleaner,
brush or paintbrush.
Clean the device. Wipe the device with a
slightly damp cloth.
DANGER! Caution, risk of injury!
Improper repairs can result in the product
functioning unsafely. This endangers your-
self and your environment.
Fault/malfunction Cause Remedy
Product not running. Device defective? Contact your local dealer.
Is the sanding disc not suitable for
material? Replace the sanding disc (
►
Attach
the sanding disc – p. 7).
Sanding power too low.
Sanding disc worn out?
GB
Schwingschleifer_381118_398214_301393.book Seite 8 Donnerstag, 17. September 2015 8:47 08