LUVERNETRUCK.COM
•
PRODUCT SUPPORT: 877.287.8634
•
570747-INS-RA
•
01/29/2021
•
ECN7969
•
PAGE 5
Step 8
Once the drilling is complete, fasten the
bracket to the pinch seam using the supplied
zinc 5/16”-18 bolts and 5/16” washers
through the retainer plate and drilled holes.
Secure with the 5/16”-18 flange nuts.
Tighten down all fasteners.
Step 9
For the third passenger-side bracket, on the
back side of the rocker panel, measure about
48-1/2” back from the front of the mud flap.
In this location there should be a body plug.
Scrape away the under coating and
remove the body plug. Measure back 1/2”
from the opening and drill a 7/16” hole
and insert the 5/16”-18 U-Nut.
Place the rear passenger-side bracket in place,
using the top slot in the bracket. Fasten with
the supplied 5/16”-18 bolt and 5/16” washer.
Snug the hardware,
but do not fully tighten.
Step 7
Once the bracket is in place, the lower mount is ready to be drilled. Use an 11/32” drill bit
to drill two holes using the two holes in the lower bracket mount as a guide.
Adjust the lower bracket if needed to ensure the two holes are fully on the pinch seam.
Step 6
Using the bracket as a guide, mark the top
mounting hole using the top slot in the bracket.
Center punch and drill a 7/32” hole.
Secure the bracket using
a 5/16” self-tapping screw.
Snug the hardware,
but do not fully tighten.
Step 5
For the second passenger side bracket, on the back side of the rocker panel, measure about 27-1/2” back from the
front of the mud flap and mark the location. This is approximately where the second bracket will be installed.
Also measure the height of the first bracket from the top of the bracket to the bottom of the
floor board and mark that location for the second bracket. This will assist with mounting the board level.
