LUVERNETRUCK.COM
•
PRODUCT SUPPORT: 877.287.8634
•
570747-INS-RA
•
01/29/2021
•
ECN7969
•
PAGE 3
Step 5
After the drilling is complete, fasten the bracket
to the pinch seam using the supplied black
5/16”-18 bolts and 5/16” washers through
the drilled holes. On the back side of the pinch
weld, place the retainer plate over the bolts and
fasten them with the 5/16”-18 flange nuts.
Tighten down all fasteners.
Step 6
For the second driver side bracket, on the back side of the rocker panel, measure about 27-1/2” back from the
front of the mud flap and mark the location. This is approximately where the second bracket will be installed.
Also measure the height of the first bracket from the top of the bracket to the bottom of the
floor board and mark that location for the second bracket. This will assist with mounting the board level.
Step 8
Once the bracket is in place, the lower mount is ready to be drilled. Use an 11/32” drill bit
to drill two holes using the two holes in the lower bracket mount as a guide.
Adjust the lower bracket if needed to ensure the two holes are fully on the pinch seam.
Step 9
Once the drilling is complete, fasten the bracket to the pinch seam using the supplied black
5/16”-18 bolts and 5/16” washers through the drilled holes. On the back side of the pinch weld
place the retainer plate over the bolts and fasten them with the 5/16”-18 flange nuts.
Tighten down all fasteners.
Step 7
Using the bracket as a guide, mark the top
mounting hole using the top slot in the bracket.
Center punch and drill a 7/32” hole.
Secure the bracket using
a 5/16” self-tapping screw.
Snug the hardware,
but do not fully tighten.
