Lutz SafetyBox, Translation Of The Original Instructions

Page: 10 / 16

10
0697-101 SafetyBo
x - 10/19
en
4. Starting up
3
Device disconnected from power supply
3
Mains socket has a shock-proof plug
4.1 Setting and testing the SafetyBox
► Hang the SafetyBox with the mounting bracket at the
intended location.
► Insert the leakage sensor into the socket on the right-hand
side of the housing (
→
Fig. 1, item 1).
► Open the hinged window on the housing ( → Fig. 1, item 2).
► Use a screwdriver to set the upper switch to "Up" ( → Fig. 2).
► Use a screwdriver to set the lower switch to 100 kΩ
( → Fig. 2).
►
Connect the SafetyBox to the power supply using the power
supply cable ( → Fig.1, item 3).
► To test the leakage sensor, insert water drop by drop into
the inlet opening of the leakage sensor until the signal
device lights up and hums.
►
Close the hinged window on the housing and disconnect
the SafetyBox from the power supply again.
► Dry the interior of the leakage sensor, e.g. with compressed
air.
Fig. 1: Setting and testing the SafetyBox
Fig. 2: Monitoring relay