3. Continue to hold all three buttons while
pushing the battery back into place. After
inserting the battery, continue holding the
three buttons for 6 seconds until the dome
LED flashes rapidly.
1. Remove the battery from the sensor.
2. Hold in the
button, Test button,
and one of the three buttons on the
back of the sensor.
4. Press the Test button to cycle through each
RF channel (15 total). Press the
button to resend the association
message at the currently selected
channel.
5. Continue to cycle through the RF channels
until you hear the Main or Aux Repeater
beep. The beep indicates that the proper
RF channel has been identified. At this
point stop pressing any of the buttons that
change the sensor’s RF channel!
6. Hold in the
Button and Test button
For 6 seconds until the dome LED stops
rapid flashing.
Now that the frequency has been matched up to the Main
Repeater, proceed with device activation as specified in the
RadioRA2 Programming Utility.
3
rd
Generation Ceiling Mount Sensors
LRF2-xCR2B
x = O for Occupancy; V for Vacancy
4
