®
Sensor Adjustments
Override Settings
1 2 3 4
1 2 3 4
Pre-installation
WARNING: SHOCK HAZARD. May result in death or serious injury.
Disconnect power before servicing or installing.
1. For installation by a qualified electrician in accordance with national and local codes and the following instructions.
2. Use copper conductors only
3. Do not connect this product to line voltage/mains cable
4. For indoor use only.
5. Check to see that the device type and rating is suitable for the application.
6. Do not install if product or lens have any visible damage.
7. If moisture or condensation is evident, allow the product to dry completely before installation.
Installation and Mounting
Number of Sensors
1
2
3
1
2
1
Number of Auxiliary
Power Packs
0
0
0
1
1
2
22 AWG
750 ft
375 ft
250 ft
375 ft
250 ft
250 ft
0.5 mm
2
365 m
180 m
120 m
90 m
120 m
120 m
20 AWG
1200 ft
600 ft
400 ft
600 ft
400 ft
400 ft
0.75 mm
2
730 m
365 m
240 m
365 m
240 m
365 m
18 AWG
2400 ft
1200 ft
800 ft
1200 ft
800 ft
800 ft
Wire Lengths (when powered by power pack)
Measurements shown as: in (mm)
2.25
(58)
3.35
(86)
2.5 (63)
0.52
(13.3)
Mounting Plate Dimensions
ON
OFF
Off (Default)
On
Automatically Turn Lights On
Manually Turn Lights On
Not Used
Not Used
LED On
LED Off
Lock Settings
Unlock Settings (any change resets learned settings)
Off (Default)
On
OFF
8 minutes
OFF
4 minutes
ON
15 minutes
ON
30 minutes
OFF
ON
OFF
ON
Auto Timer Adjust On
Auto Timer Adjust Off
Auto Senstivity Adjust On
Auto Sensitivity Adjust Off
}
}
}
}
ON
OFF
Mounting to Wall or Ceiling Tile:
Drill wiring routing hole
and (2) mounting holes
using Mounting Bracket as
template. Route building
wires through routing hole
and mounting bracket.
Secure mounting bracket to
wall/ceiling tile using mounting
screws, nuts, and washers (included).
Mounting in Acoustic Ceiling Tile:
Insert ACAK into mounting bracket and twist
90˚ to lock in place. Drill through ceiling tile with
assembly,using the cutter end and the threaded
mounting post. Secure with washer and nut. Route
house wires through ACAK.
ACAK
Acoustic
Ceiling
Adaptor Kit
(optional
Wiring
Sensor:
1.
Route wiring harness through mounting post.
2.
Connect building wires to wiring harness with twist-on wire connectors.
3.
Snap bracket cover in place to conceal wiring and bracket.
4.
Feed wiring harness through the back of the sensor body and out the exit slot.
5.
Snap sensor onto mounting post. Plug wiring harness into connector on the left side (opposite exit slot)
and place wiring under wire tabs. Align sensor and tighten position locking screw.
6.
Replace sensor cover
Cutter end
Bracket
Cover
Wiring
Harness
Locking Screw
loosen
tighten
Mounting
Post
Exit Slot
Sensor
Cover
A
B
Auto/Manual
NA
LED Motion Indicator
Reset Learned Settings
Timer Adjust
Auto Sensitivity
}
Manual