Part of the Limelight by Lutron System
Limelight by Lutron
Field-installable Radio Sensor Module
Installation
Please read before installing
041662
Rev. F
03/2021
Lutron Electronics Co., Inc. 7200 Suter Road
Coopersburg, PA 18036-1299 USA
Troubleshooting
Radio State
LED State
Description
Not functioning
Not lit
Need to check wiring
Waiting to join network
Solid on
Initial install: pre-commissioning
Joined to a network
Blinking: 1 sec on, 1 sec off
RF mesh is built; normal operation
Received message
Blinking: 50 ms on, 50 ms off, 10 times
RF communication to/from the gateway
Occupancy sensor detected
Blinking: 200 ms on, 50 ms off, 40 times Internal circuit boards are properly
connected (at startup/reset only
–
blinking
will stop once it is commissioned correctly)
1.
2. Luminaire power-up timing: When the device powers up, it cycles the luminaire through various states so the
manufacturer can determine if the luminaire has been wired correctly. The power-up sequence is as follows:
Light State
Low
Off
Low
Medium
High
Duration
1 second*
For 1 second*
For 3 seconds
For 3 seconds
Indefinitely
* This value may vary depending upon driver capacitance variation.
3. Fixture stays at high end.
–
Is the gateway powered and commissioning process completed?
Sensor won’t dim lights until it’s been
commissioned in a system (aside from powerup timing described in #2 above).
– 0–10 V
-
wires are not connected properly.
4. Sensor doesn’t turn lights OFF.
–
Is the gateway powered and commissioning process completed?
Sensor won’t turn lights OFF until it’s been
commissioned in a system.
–
Is Red wire from LL-EXTMOUNT connected properly?
Customer Assistance www.lutron.com/support
