R
20
LCP128
TM
Setup and Maintenance Guide
STEP 1 (continued)
High/Low End Trim Setup
High and low end trim settings limit the maximum
and minimum output of a dimming circuit. Levels
are set automatically when the load type is
assigned. You should change the high or low end
trim for a circuit only if the default setting needs to
be adjusted.
A.
From the
Main Menu
use and to
highlight
Panel Setup
and
press or (OK).
B.
Use and to
highlight
Load Setup
and press
or (OK).
C.
Use and to
highlight
High End Trim Setup
or
Low End Trim Setup
and
press or (OK).
D.
For each dimming circuit, use
and
to select
the circuit and
and
to set the trim level. Non-
dimming, motor, and fan circuits are set to NA (not
any).
E.
When all the trim levels are set press
or
(Done).
OK
OK
OK
OK
Load Setup
High End Trim Setup
Load Type Setup
Low End Trim Setup
Chicago Setup
Back
OK
C.
High End Trim Setup
001
Dim
- 90%
002
Dim
- 95%
003
Relay
- N A
Cancel
Done
D.
All Circuits
-
Caution!
Do not reduce the low end trim on a
fluorescent load type. This will decrease lamp
life and may damage ballasts.