Here are the
4 steps
to designing an EcoSystem:
Step
Ballast Selection
A
Determine number of fixtures that will be connected to EcoSystem.
Note: Do not consider control zones, since they will be programmed rather than wired.
B
Classify the type of ballast in each fixture.
Note: Use a Ballast Module Fixture-mounted (BMF) in conjunction with a ballast for dimming
down to 1% or for lamp types where EcoSystem is not yet available. A BMF connected
to any Eco-10
™
or Hi-lume
®
ballast gives full EcoSystem functionality to that ballast.
Step
Sensor/Receiver Selection
Determine what sensors should be connected to EcoSystem.
Note: EcoSystem ballasts are compatible only with EcoSystem daylight sensors.
1
2
EcoSystem T8 Digital Ballast
pg. 06
EcoSystem Ballast Module Fixture-mounted (BMF)
pg. 07
20VDC Occupancy Sensor
pg. 10
EcoSystem Daylight Sensor
with IR Receiver
pg. 08
EcoSystem IR Receiver
pg. 12
EcoSystem T5 Digital Ballast
pg. 06
04
|
Lutron
www.lutron.com/ecosystem Lutron World Headquarters:
1.610.282.3800
EcoSystem
™
|
how to design a system
