Lutron Electronics CS-YJ-4GC-WH Setup Manual Download Page 2

Shading Solutions

4-Group RF Remote Control

Models CS-YJ-4GC-WH, CS-YK-4GC-WH • Setup Guide—Please Read Before Operating

English

Lutron Electronics Co., Inc.

7200 Suter Road

Coopersburg, PA 18036-1299, U.S.A.

02/2015

P/N 045411 Rev. D

Lutron, 

O

, Serena, Sivoia, Triathlon, HomeWorks, and RadioRA are registered trademarks of Lutron Electronics Co., Inc.

Battery Replacement

Troubleshooting

Restore Factory Default Settings

Limited Warranty

For Assistance:

The Lutron

®

 4-Group RF remote control uses 2 AAA alkaline 

batteries which are pre-installed. 
For longest battery life, alkaline batteries are recommended.

To replace batteries:

1. Remove the battery cover 

from the back of the control

Press here

WORLD 
HEADQUARTERS

Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036
United States
Tel: +1.610.282.3800
Fax:+1.610.282.1243

CUSTOMER 
SERVICE/ORDERING

USA: 1.888.588.7661
08.00 - 20.00 EST 
UK: +44-(0)20.7702.0657
09.00 - 18.00 GMT

TECHNICAL SUPPORT 

USA: 1.800.523.9466
24 hours/7 days
UK:+44.(0)20.7702.0657
09.00 - 18.00 GMT

INTERNET: 

www.lutron.com
www.forums.lutron.com
[email protected]

UNITED KINGDOM

Lutron EA Ltd. - London
Lutron House
6 Sovereign Close
Wapping, London E1W 3JF
England
Phone: +44.(0)20.7702.0657
Toll Free (In-country only): 
0800.282.107
Fax: +44.(0)20.7480.6899
[email protected]

Lutron will, at its option, repair or replace any unit that is defective in materials or manufacture 
within one year after purchase. For warranty service, return unit to place of purchase or call 
Lutron Customer Service at 1.888.LUTRON1.

This warranty is in lieu of all other express warranties, and the implied warranty of merchant-
ability is limited to one year from purchase. This warranty does not cover the cost of installation, 
removal, or reinstallation, or damage resulting from misuse, abuse, or damage from improper 
wiring or installation. This warranty does not cover incidental or consequential damages. 

LUTRON’S LIABILITY ON ANY CLAIM FOR DAMAGES ARISING OUT OF OR IN CONNECTION 
WITH THE MANUFACTURE, SALE, INSTALLATION, DELIVERY, OR USE OF THE UNIT SHALL 
NEVER EXCEED THE PURCHASE PRICE OF THE UNIT.

This warranty gives you specifi c legal rights, and you may have other rights which vary from 
state to state. Some states do not allow the exclusion or limitation of incidental or consequential 
damages, or limitation on how long an implied warranty may last, so the above limitations may 
not apply to you. 

©2014 Lutron Electronics Co., Inc.

FCC/IC Information

This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS 

standard(s). Operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired 

operation. Modifi cations not expressly approved by Lutron Electronics Co., Inc. could void the 

user’s authority to operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of 

the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected

• Consult the dealer or an experienced radio/TV technician for help

CE Information

For model number: CS-YK-4GC-WH

Lutron Electronics hereby declares that the models listed above are in 

compliance with the essential requirements and other relevant provisions of 

Directive 1999/5/EC. A copy of the DoC can be obtained by writing to: 

Lutron Electronics Co., Inc., 7200 Suter Road, Coopersburg, PA 18036 U.S.A.

Symptom

Probable Cause and Action

Buttons don’t light up 

when they are pressed.

Dead, low, or no batteries in wireless control.

•  Install new batteries.

Batteries are installed incorrectly 

(reversed polarity).

•  Install batteries as indicated under 

Battery 

Replacement.

A specifi c window 

treatment does not 

respond when a button 

is pressed.

The window treatment is not assigned to the 

control.

•   Follow the instructions under 

Assignment to 

a Serena

®

 or Sivoia

®

 QS Triathlon

®

 Shade.

Devices are out of range.

•   Check to make sure the remote control and 

window treatments are within 30 ft (9 m) of 

each other.

Individual Shade 

Groups respond, but 

the All Shades button 

does not work

Repeat group assignment and select the All 

Shades button.

Note:

 Returning the Lutron

®

 4-Group RF remote control to its factory 

default settings will remove all shade assignments and erase all 
programming from the control.
Step 1: Tap the All Shades button.
Step 2: Tap the Open or Close button 3 times, (triple-tap), then press and 

hold. The All Shades button LED will illuminate and stay on for 
approximately 3 to 5 seconds while you continue to hold.

Step 3:  Keep the button pressed until the All Shades button LED turns 

off.

Step 4: Release the button and immediately triple-tap it again; (do not 

hold). The LED’s of Shade Group buttons 1 - 4, and the All 
Shades button will illuminate and stay on for approximately 
3 to 5 seconds. When all LED’s turn off, the control has been 
restored to factory default settings.

2. Replace with 2 AAA alkaline 

batteries, oriented as shown

3. Reinstall the 

battery cover

Slide the 

battery 

cover off

Summary of Contents for CS-YJ-4GC-WH







Reviews: