Luna 24752-0109, Manual

Page: 31 / 84

31
Another method is to depress the trigger assembly, then, repeatedly impact the safety
bracket. The tool can repeatedly drive the fasteners. The tool will drive one fastener when
the safety bracket is impacted one time.
This method is working in the non-accurate position so using this method will increase
work efficiency.
1. Original factory setting is single sequential trigger mode.
2. Read and understand operating manual before changing the trigger mode. Improper use
may result in serious injury.
3. Manufacturer assumes no responsibility for any injuries and loss caused by any improper
use of this tool.
CAUTION:
Remove finger from trigger when not driving fasteners. Never carry tool with
finger on trigger: tool will fire a fastener if safety is bumped.
Keep tool pointed in a safe direction at all times.
Never attempt to drive a fastener into material that is too hard, or at too steep an angle, or
near the edge of the workpiece. The fastener can ricochet causing personal injury.
Disconnect tool from air supply before performing maintenance, clearing a jammed
fastener, leaving working area, moving tool to another location, or handing the tool to
another person.
Clean and inspect tool daily. Carefully check for proper operation of trigger and safety
mechanism. Do not use the tool unless both the trigger and the safety mechanism are
functional, or if the tool is leaking air or needs any other repair.
Adjusting the nailing depth
Driving depth will be adjusted by adjusting adjuster (A) Fig. 6. Test fire a fastener
and check depth. If the nail is driven too deep, rotate the adjuster to make safe bracket
downward. Whereas, rotate the adjuster counterclockwise to make safe bracket upward
Repeat this step to achieve desired results. (See Fig. 7)
Figure 6 Figure 7