Luna 24752-0109, Manual

Page: 30 / 84

30
Figure 2 Figure 3
Figure 4 Figure 5
Using the tool
Complete all steps of Loading the fasteners before using the tool.
This tool can be fired in two different ways:
This tool can be fired using either trigger fire (single sequential) or dual-action (bump fire).
Trigger firing (single sequential): Turn the rotating shaft so the tail of the rotating shaft is
up.
When safety bracket is pressed against the work place, push the trigger repeatedly, and the
nails can be shot continuously.
Dual-action (bump fire): Turn the rotating shaft so the tail of rotating shaft is down.
1. Trigger firing:
Put the nose on the working surface, lightly push the tool toward the working surface until
the safety bracket is depressed, and then depress the trigger to drive the fasteners. This
“trigger fire” method provides the most accurate fastener placement. In this method, the
safety bracket can be adjusted downwards with knob to avoid striking two nails at one time.
2. Duo-action firing:
One method is to put the drive guide on the working surface, lightly push the tool toward
the working surface until the safety bracket is depressed, then depress the trigger assembly
to drive the fasteners. Due to the rebounding of the nailer, the safety bracket will be
depressed again, causing a double hit. The tool will then fire two nails in the same time or
one fire, one blank.