Luna 20463-0305, Original Instructions Manual

Page: 54 / 120

52
Figure 7
Figure 8
Figure 9
Figure 10
Sliding rail
3
1
Figure 6
Feeder base
Feeder arm
Feed roller
ass’y
Startype screw
Anti-kick-
back ass’y
2. Place the Feeder Ass’y and Anti-kickback Ass’y onto the
Feeder Arm and secure it.
4.7 Installing the Sliding Carriage (optional)
4.7.1 Installing the sliding bench
1. Fit the scale mount (1) to the sliding bench.
2 allen bolts M6x16
2. Insert the intermediate plates (2) into the stop tube do not
tighten the screws.
2 washers 6mm
2 thumbscrew M6
3. Fit the stop tube on the sliding bench.
1 swing bolt
2 washers 8mm
1 Wave washer 8mm
1 hex nut M8
The wave washer must be between the stop tube and the sliding
bench.
4.7.2 Adjust the scale mount
1. Release the 2x allen bolts M6x16 and shift the scale mount to
the left or to right make sure the pointer with the “0” scale. then
tighten the 2x allen bolts
2. Slide the guide rail (3) over the intermediate plates (2) and
tighten the thumbscrews.
3. Insert the folding stop (4) into the end stop and tighten the T-
screw.
4.7.3 Mounting bracket
Fit the two mounting brackets with two "I" shape insert block to
machine housing.
4 allen bolts M8x45
4.7.4 Mounting the sliding rail
Insert the Sliding rail from above at a slight angle into the moun-
ting brackets and tighten the wing nuts.
4.7.5 Mounting the sliding bench
1. To mount the sliding bench on the sliding rail, unlock the stop
bolt.
2. Pull out the ball knob and turn clockwise or counter-clockwi-
se (1/4turn).
3. Slide the bench on the sliding rail, ensuring that the bearings
line up correctly and the bench runs smoothly.