brightness down to avoid image flickering and to preserve the battery life.
During nighttime you could increase the brightness all the way up, however
when utilizing built-in or external IR illuminator, you may need to tone the
brightness down a bit.
ELECTRONIC IMAGE MAGNIFICATION ZOOM:
Your unit is also equipped with electronic zoom function, which allows you to
change image magnification from 6x to 30x. To increase the image
magnification press the IMAGE button (11) on the + side and look into the
ocular – you will see the image magnification increase. At the minimum level
(1.00) the image magnification is 6x; at the maximum level (5.00) the image
magnification is 30x. You can see the zoom level in the right lower corner of
the image screen once you start pressing the IMAGE button on the + side. To
decrease the image magnification, press the IMAGE button on the – side.
USING INFRARED ILLUMINATOR:
Your digital viewer is equipped with a built-in powerful Infrared illuminator
light (10). This light operates in a spectrum, which is normally invisible to a
human eye, however with the help of the CCD sensor, located inside the unit,
you will see a beam of light when looking though the ocular lens. Since the
CCD does not actively amplify the available light, you will need to utilize the IR
illuminator often in the nighttime conditions.
To turn the Infrared illuminator ON, press the Infrared illuminator button (13)
momentarily – image will remain full color. To switch image to night vision
green – press IR button again. To switch image to B&W press the IR button
again. To turn the IR illuminator OFF press the same IR button again once. A
red light indicator located in the back of the unit will light up indicating the IR
Illuminator is on and will disappear when the IR illuminator is off.
When using the infrared illuminator it is important to remember that like a
flashlight, it is brightest when used in short distances. As the distance
increases, the intensity of the infrared light fades away.
Extended range IR illuminators are available (model LN-EIR-2, or LN-ELIR-2),
which can be mounted into the accessory/tripod mount (4)
TAKING PICTURES AND RECORDING HD VIDEOS:
Your digital viewer has the ability to take pictures
and record HD videos onto the external Micro-SD
card. 8GB card is included with your unit and it is
already installed into the SD-card slot. The Micro-
SD card can be upgraded up to 128GB, which is
especially useful if you plan to record a lot of
videos. To change the SD-card, open the SD-
card/USB compartment (7) by sliding the latch to the right. The door will pop
open as you see on the image on the previous page. Remove the included
16
15
