lumishore TIX402, Installation And Operation Manual

Page: 4 / 13

Page 4
2.0 TIX402 INTERCHANGEABLE FLUSH FIT THRU-HULL CAMERAS
Bonding Attention :
Failure to bond the cameras properly and maintain the appropriate protection will invalidate the LUMISHORE warranty.
LUIMISHORE camera
s should be connected to the vessel’s DC Bonding system to ensure protection from electrolytic /
galvanic corrosion. All bonding connections should be fully checked prior to returning the vessel to the water.
LUMISHORE cameras have integrated circuitry to protect cameras from external issues, but these are dependent upon
correct bonding. Bond to the bolt on the locking ring (yellow connection tab is supplied).
Installation Considerations
● Location – positioning will be dependent on both external and internal obstacles; consideration should also be
given to installation wiring and internal access within the vessel. Ideally the camera modules should be
installed 6” to 10” (150-250mm) below the surface water line.
● Select a flat surface; make sure that both the internal and external surfaces of the hull are even and parallel.
It may be necessary to sand or grind the surface.
● A hole will be drilled to allow the Thru-Hull Camera Assembly to be inserted; care must be taken to ensure
there is unrestricted access inside the hull.
● Confirm there is clearance (more than 7”) inside the hull to be able to remove the Camera Insert Module.
● The camera is temperature sensitive and must not be located close to the exhaust.
2.1 Materials and Dimensions:
Cable: 3'3" (1 meter)