Page 3
1.0 BEFORE YOU START
●
HD Camera - DO NOT touch camera glass. Take care to keep the camera glass clean during handling
and installation.
● Always ensure that the vessel’s power source and battery are disconnected or isolated prior to installation.
● A qualified professional should carry out both electrical and mechanical installation. If in doubt please contact
LUMISHORE. Refer to Product Support Section.
● Always use a suitable fuse or circuit breaker to protect the complete system. Each camera should be
individually fused using the fuse holder supplied with the camera. Make sure to choose the correct fuse size
for the 12 Volt supply.
● The Thru-Hull maybe installed into GRP (Glass Reinforced Plastic or Fiberglas) and wooden hulls.
● The camera should be installed 6”-10” (150-250mm) below the surface of the water although this is not
critical.
● Never try to install or remove the thru-hull fitting or the Camera Insert Module with the vessel in the water.
● Confirm there is clearance (more than 7”) inside the hull to be able to remove the Camera Insert Module.
● The camera should not be exposed to any temperatures in excess of 150°F (65°C). For example, next to hot
engine components or where exhaust emissions could be expelled onto the camera while underway.
● Do not over tighten the retaining nut.
● All LUMISHORE Thurs Hull products should have bonding to the DC system via bonding strap for galvanic
protection.
● Caution: NEVER leave the vessel unattended in water if the Camera Insert Module is not in place
Note: Before mounting the camera, record the serial number for future reference. The number is located on the
back of the camera.
Summary of Contents for TIX402
Page 12: ...Page 12 NOTES...
