Full product range & more information:
www.lumenalights.com
SOLLUX TECHNOLOGY:
The Sollux is a highly efficient, high output solar light with high capacity Lithium Ion batteries and a fast charging Polycrystalline solar panel. This
means that even on partially cloudy and rainy days, it will re-charge efficiently. The high battery capacity gives enough power for multiple
nights, particularly when the tier option is used. The high lumen light output is bright enough to illuminate areas of up to 150m².
INSTALLATION:
The Sollux is designed to be mounted into soft ground via the 2x aluminium spike supports, with the solar panel located up to approximately
4.5m away to ensure maximum light exposure. The panel can be surface mounted or spike mounted into soft ground. Ideal as an up light for
larger trees. A 5m extension cable is available to extend the distance between solar panel & flood light
–
this may increase the charging time
slightly.
Location
–
It is important that the installation location of the solar panel is carefully considered, avoiding shady areas. The best position for
the solar panel is south facing; however, it will still charge the battery when facing in other directions, especially when in full sunshine. Ensure
there are no other lights which could interfere with the light sensor, imitating daylight.
1.
Plug the flood light into the solar panel and secure in place by screwing on and fully tightening the cap.
2.
Experiment with desired position of both the flood light and solar panel, ensuring there is enough slack in the cable to safely hook up
when they are mounted in the desired location.
3.
Once happy with the positioning, follow relevant installation method below:
SPIKE MOUNT
a.
Attach the short spikes to the floodlight with the socket screws and lock washers provided (in
flood light)
–
see image.
b.
Dampen the soil in desired location and use a rubber pallet to securely mount the spikes (evenly).
End caps provided if preferred.
c.
Attach the longer spikes to the solar panel with the socket screws and lock washers provided (in
battery pack)
–
see image.
d.
Position the solar panel horizontally so that the spikes protrude higher than the panel.
e.
Dampen the soil in desired location and use a rubber pallet to securely hammer the spikes into the
ground, alternating between spikes. End caps provided if preferred.
SURFACE MOUNT (Panel Only)
a.
Mark the mounting holes of the solar panel bracket in the desired location.
b.
Drill out the holes and use relevant screws / plugs for the mounting surface (not included) and
secure the solar panel bracket in place.
c.
Attach the solar panel to the bracket with the 2 x socket screws, washer and nut provided in the
battery pack (washer and nut on outside of bracket
–
hold the allen key inside the socket screw and
tighten the nut with a spanner).
4.
Adjust the angle of the solar panel & flood light, as desired, and tighten into position with the allen keys
provided. Adjust solar panel to approx. 45 degrees for maximum charge effectiveness.
5.
Check the waterproof cable connector is secure and cable is in a safe position.
6.
Press the dusk to dawn button on the remote to activate the dusk to dawn setting & test the flood light (batteries will need to be
inserted).
MODES / SETTINGS:
NOTE: When the remote is turned
“
ON
”
, the previous setting will be remembered. Timer setting will start instantly, regardless of daylight.
Digital Display of Battery Charge Percentage.
Before use, insert the batteries into the remote control.
For first use, press the
“
AUTO
”
button on the solar light control panel to
activate the light and remote.
To switch between modes, select the relevant button for the desired setting after
installation.
Modes can be changed via the remote control, up to 20m.
Override
“
ON
”
button will remember the previous mode set, and
“
OFF
”
will be
overruled the following evening.
Remote control can command more than one fitting in range.
Infra-red sensor is located in the bottom left corner of the flood light lens.
