Lumel SMC series, User Manual

Page: 8 / 24

8
The RS-232 interface signals are led out to terminals 12, 13 and 14. The USB interface is available on the
controller frontal plate. RS-485, RS-232 and USB interfaces are connected to the Port 2 and cannot be used
simultaneously.
The current program on a CD is included in the controller set.
The current programming package for SMC is included on the
www.lumel.com.pl/download page.
All updatings can be carried out by means of the programming package runs on this page.
The tool package CPDev (Control Program Developer) serves to program the SMC controller. It is composed
of:
- compiler CPDev,
- program simulator CPSim
- communication configurer CPCon.
Three libraries complete the package - IEC_61131, Basic_blocks and Complex_blocks.
4.3. Installing COM Port for Windows
The controller USB Port takes advantage of the program which is created in the system by the new USB
Serial Converter device and the Port (Com) assigned to him – USB Serial Port. The installation of the
controller in the Windows system causes the addition of a successive serial COM Port to the list of ports
serviced by the operating system.
4.4. Installing COM Port Controllers in the Computer
.
On the CD added to the product, there are catalogues with controllers for following operating systems:
-
WIN_XP: Windows 2000, Windows XP, Windows Vista, Windows Server 2003.
- WIN_XP_64: Windows Vista x64, Windows XP x64, Windows Server 2003 x64.
NOTE: Controllers do not co-operate with Windows 98 and ME systems.
Installation in Windows 2000, Windows XP, Windows Vista and Windows Server 2003 systems.
In order to install controllers for these systems, one must start the program realizable from the catalogue
with the controller for the given system:
-
WIN_XP\CDM_Setup.exe (for Windows 2000, Windows XP, Windows Vista and Windows Server
2003)
- WIN_XP_64\ CDM_x64_Setup.exe (for Windows XP x64, Windows Vista x64 and Windows
Server 2003 x64).
This program will install controllers for new devices and ports in the system.
Next, one must connect the controller, which will be found and identified by the system, as USB serial
converter, and the Port (Com) will be assigned to it – USB Serial Port.