16
EN
4.1. Programming of controller parameters
The pressure and holding down the
button during ca 2 seconds
causes the entry in the programming matrix. The programming matrix
can be protected by an access code. In case when giving a wrong value
of the code, it is only possible to see settings through – without possibi-
lity of changes.
The fig 8. presents the transition matrix in the programming mode.
The transition between levels is carrying out by means of the
and
buttons and the level choice by means of the
button. After
choosing the level, the transition between parameters is carried out by
means of
and
buttons. In order to change the parameter
setting, one must proceed acc. to the section 6.3. (see full version of
service manual, available at www.lumel.com.pl). In order to exit from the
selected level, one must transit between parameters until the symbol
[. . .] appears and press the
button. In order to exit from the pro-
gramming matrix to the normal working mode, one must transit between
levels until the symbol [. . .] appears and press the
button.
Some controller parameters cannot be visible – it depends on the cur-
rent configuration.
The table 1 (see full version of service manual, available at www.lumel.com.pl)
includes the description of parameters. The return to the normal wor-
king mode follows automatically after 30 seconds since the last button
pressure.
