Lumberjack SCMS254SB, Safety And Operating Manual

Page: 12 / 24

2
AIR6V 01 AIR6V 01 AIR6V 01 AIR6V 01
SCMS254SB 10
OPERATION
Turning on and off
1. To turn on the saw, press the lock backward 1
and squeeze the trigger switch 2.
2. Release lock button and trigger switch to shut
off.
Dust extraction
1. Fit the dust bag (9) to the dust extraction port.
2. A vacuum dust extraction device can be
connected to the dust extraction port. Use a
suitable vacuum adaptor if necessary. The dust
extraction port has an internal diameter of 40
mm.
Setting the table square with the blade
1. Make sure that the electrical plug is removed
from the power point.
2. Push the saw arm (1) down to its lowest
position and engage the release knob (2) to hold
the saw arm in the transport position.
3. Loosen the mitre locks (18) and lifting up the
mitre latch(19) .
4. Rotate the table (14) until the pointer is
positioned at 0°.
5. Release mitre latch(19) and tighten the mitre
locks (18).
6. Loosen the bevel lock (10) and set the saw
arm (1) at 0°bevel (the blade at 90°to the mitre
table). Tighten the bevel lock (10).
7. Place a set square against the table (14) and
the flat part of the blade.
8. Rotate the blade by hand and check the blade-
to-table alignment at several points.
9. The edge of the set square and the saw blade
should be parallel.
10. If the saw blade angles away from the set
square, adjust as follows.
11. Use an 10 mm wrench or adjustable wrench to
loosen the lock nut securing the 0° bevel
adjustment screw (27). Also, loosen the bevel lock
(10).
12. Adjust the 0° bevel adjustment screw (27)
using a 4 mm hex key to bring the saw blade into
alignment with the square.
13. Loosen the Phillips head screw holding the
pointer of the bevel scale (11) and adjust the
position of the pointer so that it accurately
indicates zero on the scale. Retighten the screw.
14. Retighten the bevel lock (10) and the lock nut
securing the 0° bevel adjustment screw (27).
Setting the fence square with the table
1. Make sure that the electrical plug is removed
from the power point.
2. Push the saw arm (1) down to its lowest
position and engage the release knob (2) to hold
the saw arm in the transport position.
3. Loosen the mitre locks (18) and lifting up the
mitre latch (19).
4. Rotate the table (14) until the pointer is
positioned at 0°.
5. Release mitre latch (19) and tighten the mitre
locks (18).
6. Using a 5 mm hex key, loosen the two screws
securing the fence (12) to the base.
7. Place a square against the fence (12)and
alongside the blade.
8. Adjust the fence (12) until it is square with the
blade.