AIR6V 01
AIR6V 01
AIR6V 01
AIR6V 01
SCMS254DB 15
OPERATION
– Adapt the fast clamp to the workpiece by
turning the threaded rod.
– Tighten the main screw in order to clamp the
workpiece.
Adjusting the Cutting Angle
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
Always tighten the locking knob (7) & (23)
firmly before sawing.
Otherwise the saw blade can become wedged in
the work piece.
Switching On
– To
start
the machine, press the On/Off switch
(
2
)
then press lever
at the same time and
keep it pressed.
Note:
For safety reasons, the On/Off switch (
3
)
cannot be locked; it must remain pressed during
the entire operation.
– For
sawing
, you must additionally press lever
in addition to actuating the On/Off switch
.
Switching Off
– To
switch off
the machine, release the On/Off
switch (
2
).
Cross Cutting
When cutting, it is not always necessary to use the
sliding carriage. In this case make sure that the
sliding carriage lock (
22
) is tightened to prevent
the saw arm from sliding.
– With the machine in working position, and the
bevel and mitre angle set to desired angles and
the workpiece clamped, loosen the sliding carriage
lock (
22
), pull handle (
1
) towards you.
– Press the On/off switch (
2
)
.
Pull down on handle
(
1
) and push the blade down through the
workpiece then away from your body.
– Once the cut is complete raise the head and
release the on/off switch (
2
).
– Wait until the blade has stopped spinning before
removing the workpiece
