AIR6V 01
AIR6V 01
AIR6V 01
AIR6V 01
SCMS254DB 11
ASSEMBLY INSTRUCTIONS
Removing blade
– Unplug the tool from the power source.
– Adjust the lock-down pin to raise the cutting
head.
– Loosen the cover plate screw (
1
) about 2 turns
with a Phillips screwdriver. Do not remove this
screw from the tool.
– Lift and hold up the lower blade guard (
2
) to
expose the threaded blade bolt (
3
).
– Press and hold the spindle-lock button (
4
) and
rotate the blade at the same time, until it is
locked in position.
– Continue to hold the spindle lock button to keep
it engaged, while using the wrench to turn the
threaded blade bolt clockwise and remove the
threaded blade bolt.
– Remove the outer flange (
5
) and the blade (
6
).
Wipe the flanges and spindle to remove any dust
and debris.
Installing blade
Unplug the mitre saw before changing/installing
the blade.
– Install a 10” (25.4 cm) blade with 5/8” (15.9 mm)
arbor onto the arbor shaft (
7
). Match the arrow on
the blade with the arrow on the upper blade
guard. Make sure that the blade teeth are pointing
downward.
– Place the out flange against the blade and on the
arbor. Thread the blade bolt onto the arbor in an
anti-clockwise direction.
– Place the blade hex wrench into the blade bolt.
